Husqvarna AUTOMOWER 420 Operator's Manual page 34

4. Save a profile for the new charging station,
or select a profile in the list. Do steps 1–4 in
To save settings to a profile on page 33 , or
To use a profile on page 33 .
do steps 1–3 in
3.12.11 ECO mode
ECO mode is activated, it switches off the
If
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
3.12.11.1 To set the ECO mode
To get access to the menu
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
ECO mode .
3. Push the OK button to select the
mode .
4. Push the BACK button.
3.12.11.2 Spiral Cutting
The product cuts the grass in a spiral pattern if
the grass is longer in an area.
be set in 5 levels:
• Low-
• Low
• Mid
• High
• High+
The level sets how sensitive the product is to
changes in grass height.
Spiral cutting is only started in the Main
Note:
area mode. Cutting in the
does not let the product to start
Spiral Cutting does not start in slopes steeper
than 15%.
To set the Spiral Cutting
34 - Installation
Settings >
ECO
Spiral cutting can
Secondary area mode
Spiral cutting .
To get access to the menu
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Spiral Cutting > Use Spiral Cutting .
3. Push the BACK button.
To set the level of Spiral Cutting
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Spiral Cutting > Use Spiral Cutting >
Intensity .
3. Use the left arrow button to select the level
of the Spiral Cutting.
4. Push the BACK button.
3.12.11.3 Slope control
In order to decrease lawn wear near the
boundary wire in slopes, the product prevents to
move in the opposite direction when the product
Slope control is enabled in
operates in a slope.
the factory settings.
To set the Slope control
To get access to the menu
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
Slope control > Use Slope control .
3. Push the BACK button.
3.12.12 General
General you can change the general settings
In
of the product.
3.12.12.1 To set the time & date
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
General > Time & Date .
3. Use the number buttons to set the time and
then push the BACK button.
4. Use the number buttons to set the date and
then push the BACK button.
5. Use the arrow buttons to set the time format
and then push the BACK button.
Settings >
Settings >
Settings >
Settings >
1201 - 004 - 25.03.2020