Symbols On The Product; Symbols On The Display - Husqvarna AUTOMOWER 420 Operator's Manual

29. Couplers for the loop wire
30. Loop wire for boundary loop and guide wire
2
3
31. Stakes
32. Connectors for the loop wire

1.3 Symbols on the product

These symbols can be found on the product.
Study them carefully.
WARNING: Read the
user instructions before
operating the product.
WARNING: Disable the
product before working on
or lifting the product.
WARNING: Keep a safe
distance from the product
when operating. Keep
your hands and feet away
from the rotating blades.
WARNING: Do not ride
on the product. Never put
your hands or feet close
to or under the product.
Never use a high-pres-
sure washer or even run-
ning water to clean the
product.
Use a detachable power
supply as defined on the
rating label next to the
symbol.
This product conforms to the
applicable EC Directives.
Noise emission to surroundings. The
product's emissions are set out in
Technical data on page 60 and on the
rating plate.
1
Is a part of the Installation kit which is purchased separately.
2
Is a part of the Installation kit which is purchased separately.
3
Is a part of the Installation kit which is purchased separately.
4
Is a part of the Installation kit which is purchased separately.
1201 - 004 - 25.03.2020
1
4

1.4 Symbols on the display

It is not permitted to dispose this
product as normal household waste.
Ensure that the product is recycled in
accordance with local legal
requirements.
The chassis contains components
which are sensitive to electrostatic
discharge (ESD). The chassis must
also be resealed in a professional
manner. For these reasons the chassis
shall only be opened by authorized
service technicians. A broken seal can
result in the entire or parts of the
guarantee no longer being valid.
The low voltage cable must not be
shortened, extended or spliced.
Do not use a trimmer nearby the low
voltage cable. Be careful when
trimming edges where the cables are
placed.
The schedule function controls when
the product cuts the lawn.
The cutting height function sets the
cutting height of the product.
The security function lets the operator
select between 3 security levels.
The messages function shows error
messages and possible cause for the
problems.
The weather timer function
automatically adapts the cutting
intervals to the grass growth.
Introduction - 5