Husqvarna AUTOMOWER 420 Operator's Manual page 32

7. If the product does not dock with the
charging station, change the position of the
charging station or the guide wire. Refer to
To install the charging station on page 21
To install the guide wire on page 23 .
and
3.12.5.3 To do a test of the boundary wire
1. Put the product 3 m / 9 ft. from the boundary
wire, facing the boundary wire.
To get access to the menu
2. Do steps 1–3 in
on page 26 .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Find charging station > Overview of
search methods > Boundary > More > Test
right / Test left .
4. Push the START button and close the hatch.
5. Make sure the product follows the guide wire
to the charging station.
6. Make sure the product docks with the
charging station.
7. Change the position of the charging station
or the guide wire if the product does not
dock with the charging station. Refer to
install the charging station on page 21 and
To install the guide wire on page 23 .
3.12.5.4 To change the signal range of the
charging station
To get access to the menu
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Overview of
search methods > Charging station range .
3. Use the left arrow button to select
MID, MIN .
4. Push the BACK button.
Note: It is usually better to move the charging
station, than to decrease the range of the
charging station signal.
3.12.6 Corridor width
The boundary wire corridor is the area adjacent
to the boundary wire and the guide corridor is the
area adjacent to the guide wire. The product uses
the corridors to find the charging station. When
the product moves in the direction of the charging
32 - Installation
station, it always moves to the left of the guide
wire.
Installation
The corridor width is adjusted automatically. Only
in rare occasions manual settings need to be
entered. The corridor width can be set between
0-9. If guide corridor width is set to 0, the product
straddles the guide wire. The factory setting is 6
for the boundary wire and 9 for the guide wire.
3.12.6.1 To set the corridor width
1. Do steps 1–3 in
on page 26 .
To
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Corridor width .
3. Use the arrow buttons to select a corridor.
4. Use the number buttons to select a corridor
width of 0-9.
Note: Make the corridor width as wide as
possible for a minimum risk of lines in the lawn.
Installation
3.12.7 Exit angle
MAX,
If the sum of the
than 100%, the product sometimes starts to mow
at the charging station. The product moves away
from the charging station with an exit angle
between 90°–270°. The exit angles can be set to
1–2 exit sectors.
3.12.7.1 To set the exit angle
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Advanced > Exit angles > Sector 1 .
3. Use the number buttons to set the angles in
degrees.
To get access to the menu
Installation
Lawn Coverage function is less
To get access to the menu
Installation
1201 - 004 - 25.03.2020