Test/Reset Button - Siemens 3RK1308‑0 00‑0CP0 Series Equipment Manual

8.2

TEST/RESET button

The RESET button has the following functions:
Designation Tripping
LED/fan test Press of a
button for less
than two
seconds
RESET function Press of a
button
Additional functions in the case of fail-safe motor starters
Confirming ATEX Press of a
parameters button
Discarding ATEX Press of a
parameterization button for longer
than five
seconds.
Displaying ATEX Press of a
parameterization button for longer
than five
seconds.
Switching to Press of a
commissioning mode button
Motor starter (3RK1308‑0**00‑0CP0)
Equipment Manual, 11/2019, A5E34821005002A/RS-AC/003
Description
The LED/fan test is activated. All LEDs (ST/OL, MAN, PWR) light up and the fan
is switched on for 4 s.
An LED/fan test is not possible in the case of fail-safe motor starters with F-DI
deactivated (safety-related shutdown by low level).
If a group fault is active, you can acknowledge this fault using the blue button.
You can acknowledge device faults in principle only via ON/OFF of the control
voltage.
Note: If a fault is active, you cannot execute the LED/fan test.
You confirm display of the parameters via an LED flashing sequence by
pressing the RESET button twice.
By pressing the button for longer than five seconds, you discard newly set ATEX
parameters and you return to the original parameterization.
By pressing the button for longer than five seconds, you can display the
currently set ATEX parameters during operation.
In "Manual local" mode, confirm the change to commissioning mode by the
fail-safe motor starter by pressing the button.
Alarms/diagnostic messages
8.2 TEST/RESET button
167