Siemens 3RK1308‑0 00‑0CP0 Series Equipment Manual page 140

Parameters/address space
7.1 Parameter assignment
Parameters for ET 200SP motor starter
The effective range of the adjustable parameters depends on the type of configuration. The
following configurations are possible:
● Centralized operation with an ET 200SP CPU and the ET 200SP Open Controller
● Distributed operation on the PROFINET IO in an ET 200SP system
● Distributed operation on the PROFIBUS IO in an ET 200SP system
When you assign parameters in the user program, transfer the parameters to the module via
the data sets with the "WRREC" statement.
The parameters that can be set can be found in the Appendix in Read/write DS201 device
parameter 1 (Page 193) and Read/write DS202 device parameter 2 (Page 196).
You will find an explanation of the parameters in Chapter Declaration of parameters
(Page 146).
Note
Changing the parameters during operation
If parameters are modified during operation, they will be overwritten by the parameters
configured in the hardware configuration during a restart of the control system.
If this is not desired, a command must be issued to disable parameterization.
You set the parameter block in theDS93 Write command (Page 190).
140
Motor starter (3RK1308‑0**00‑0CP0)
Equipment Manual, 11/2019, A5E34821005002A/RS-AC/003