REMOVING THE HEATER, THE HIGH-LIMIT
THERMOSTAT, & THERMAL CUTOFF
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug dryer or disconnect power.
2.
Remove the two hex-head screws from
the bottom flange of the toe panel. Pull the
panel out at the bottom, pull down, and
remove the panel.
Toe Panel
Toe Panel Screws
Thermal Cutoff, & Heater Area
(ELECTRIC DRYERS ONLY)
High-Limit Thermostat,
3.
Remove the hex-head screw from the
heater shield and remove the shield.
Heater
Shield
Screw
4.
To remove the heater:
a) Remove the two wires from the termi-
nal block (see photo in step 5).
b) Remove the hex-head screw from the
heater housing, and slide the heater
out of the duct.
4-10
Heater Housing
Screw