Removing The Thermal Fuse, Thermistor, Drive Motor, & Belt Switch - KitchenAid Ensemble KGHS01PMT/WH Technical Education

REMOVING THE THERMAL FUSE, THERMISTOR,
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Open the dryer door and remove the lint
filter screen, then close the door.
Lint Filter Screen
4. Remove the two hex-head screws from
the bottom flange of the toe panel. Pull the
panel out at the bottom, pull down, and
remove the panel.
Toe Panel
Toe Panel Screws
DRIVE MOTOR, & BELT SWITCH
5. Remove the hex-head screw from the lint
duct bracket and remove the bracket.
6. Remove the two hex-head screws from
the lint duct and remove the duct.
Lint Duct Bracket & Screw
7. To remove the thermal fuse or ther-
mistor:
a) Remove the two wires from the termi-
nals.
b) Remove the two hex-head screws.
2 Cover Screws
Continued on the next page.
4-7
Lint Duct Screws
Thermal Fuse
(2 Screws)
Thermistor
(2 Screws)
Blower Cover