KitchenAid Ensemble KGHS01PMT/WH Technical Education page 31

4. Move hinge to the other side and reattach
with the 4 screws removed in step 2.
5. Move handle bracket to the other side
and reattach with the 2 screws removed in
step 3.
6. Set the inner door assembly aside.
Reinstalling The Door
1. Check for fingerprints on the glass. Clean
if necessary.
2. Place the inner door assembly into the
outer door assembly. Align the hinge in the
opening on the side. To fit correctly, the
inside door assembly edge is completely
inside the outside door assembly edge.
3. Reassemble the inner and outer door as-
semblies with the 6 screws.
4. Replace the 2 handle screws for the door
handle of the door assembly.
5. Use a small flat-blade screwdriver to re-
move hole plugs in the door opening. Slide
the head of the screwdriver under the cap
of each hole plug, being careful not to
scratch the dryer surface. Lift up. Remove
the hole plugs in the door opening and
insert in the opposite side.
6. Insert a screw in the second opening from
the top of the hinge opening and partially
tighten. Hang the door by placing the top
hinge keyhole over the second screwhead
and tighten the screw. By putting this
screw in first, the door will hang in place
while you insert and tighten the remaining
4 screws.
1
1. Dryer door
2. Dryer
3. Insert this screw first
7. Close the door and check that it latches
securely.
COMPLETE THE INSTALLATION
1. Check to be sure all parts are now in-
stalled. If there is an extra part, go back
through the steps to see which step was
skipped.
2. Check to be sure you have all of your tools.
3. Dispose of all packaging materials.
4. Check the dryer's final location. Be sure
the vent is not crushed or kinked.
5. Check to be sure the dryer is level (see
"Level Dryer" on page 2-18).
6. Plug into a grounded 3-prong outlet. Turn
power on.
7. Remove the blue protective film on the
console and any tape remaining on the
dryer.
8. Wipe the dryer drum interior thoroughly
with a damp cloth to remove any dust.
9. Set the dryer on a full heat cycle (not an air
cycle) for 20 minutes and start the dryer.
Continued on the next page.
2-21
2
3