Miele H 7860 BPX Operating And Installation Instructions page 90

Cleaning and care
Finalising pyrolytic cleaning
When the time remaining has fully
elapsed, a message will appear in the
display to tell you that the door is
unlocking.
Finished will appear in the display and a
buzzer will sound as soon as the door
has been unlocked.
 Confirm the message shown with OK.
 Select
.
Close
 Switch the oven off.
The visual and acoustic signals will
switch off.

Danger of injury caused by hot
surfaces.
At the end of the pyrolytic cleaning
programme, the oven will still be very
hot. You could burn yourself on the
heating elements, oven compartment
or accessories.
Allow the heating elements, oven
compartment and accessories to
cool down before removing any
residues or oiling the side runners.
 Clean the oven compartment and
accessories suitable for pyrolytic
cleaning to remove any pyrolytic
residues (e.g. ash) that can build up
depending on the degree of soiling in
the oven compartment.
 Remove any residues from the cover
of the camera. You can use the
scouring pad on the back of a
washing-up sponge.
90
 Add a few drops of heat-resistant
cooking oil to some kitchen paper
and use this to lubricate the side
runners.
Most residues can be removed with
hot water, a little washing-up liquid
and a clean sponge or a clean, damp
microfibre cloth.
Depending on the degree of soiling, a
visible deposit could build up on the
glass on the inside of the oven door.
This can be removed with a
dishwashing sponge, a glass scraper
or a stainless-steel spiral pad (e.g.
Spontex Spirinett) and a little washing-
up liquid.
There is a delicate fibreglass seal
around the oven compartment to
seal the glass in the oven door. This
can be damaged by rubbing or
scouring.
Avoid cleaning the fibreglass seal.
Enamelled surfaces can be
permanently discoloured by spilt fruit
juices. Such discolouration does not
affect the properties of the enamel.
Do not attempt to remove these
stains.
Extending and retracting the FlexiClip
runners
After cleaning, discolouration or light
patches can remain on the FlexiClip
runners. However this does not affect
their operation.
 Extend and retract the FlexiClip
runners several times after running
the pyrolytic cleaning programme.