Installing The Oven - Miele H 7860 BPX Operating And Installation Instructions

Installing the oven

For safety reasons, the oven may
only be used when it has been fully
installed.
The oven requires a sufficient supply
of cool air for efficient operation. The
required supply of cool air must not
be excessively heated by other heat
sources (e.g. solid fuel stoves).
The following must be observed
when installing the appliance:
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit heat insulation strips to the
side walls of the housing unit.
 Connect the oven to the electrical
supply.
Use the handle cut-outs on the side of
the housing to lift the appliance. It is a
good idea to remove the door (see
"Cleaning and care" – "Door removal")
and to remove the accessories before
installing the appliance. This makes
the oven lighter when you push it into
the housing unit.
 To remove the door, use the opener
supplied to prise the door open. You
can also pull the door open by
grasping the sides of the door with
both hands and pulling carefully until
it opens.
 Remove the door (see "Cleaning and
care" – "Door removal") and take the
accessories out of the oven.
 Push the oven into the housing unit
and align it.
 Reconnect the mains power to the
isolator switch.
 Touch the  sensor control to open
the door if you have not removed it
already.
 Use the screws supplied to secure
the oven to the side walls of the
housing unit.
 Refit the door if necessary (see
"Cleaning and care" – "Fitting the
door").
Installation
113