Table of Contents
Advertisement
x. Image in the window should be aligned like figure 12.
xi. If it is not, adjust prism until it is.
xii. Return to setup screen. Mouse click on button, "Return to Setup."
www.paceworldwide.com
Figure 12
1. Loosen the setscrews from the light adjustment knobs (Figure
13)
2. Remove the knobs
3. Remove the four screws (2 on each side) from the cameras'
sheet metal cover (Figure 13)
4. Remove the cover
5. Loosening the top screws (A) and tightening the bottom screws
(B) adjusts the prism down.
6. Loosening the bottom screws (B) and tightening the top screws
(A) adjusts the prism up.
7. Loosening the right center screw © allows you to rotate the prism
around the y-axis.
8. Replace the cover
9. Replace the four screws
10. Replace the knobs
11. Adjust the light adjustment knobs and tighten the setscrews
System Operations Manual
Page 18 of 38
Advertisement
Table of Contents
