Table of Contents
Advertisement
i
ii
iii
iv
v
vi
vii
viii
ix
x
www.paceworldwide.com
e. Set up screen features. (Figure 4)
i. Set Password. Setup and profile settings can be password protected.
ii. Set Language. Software text language can be changed.
iii. Set temperature for Celsius or Fahrenheit.
iv. Set yellow temperature reference lines on the profile graph.
v. Set setback time. Machine will go into setback after selected idle time.
Setback reduces heater temperatures during extended idle times to
extend heater life.
vi. Set auto shutoff time. Machine will completely shut down after selected
idle time.
vii. Set the limit on the focus range and nozzle movement.
viii. Set setback and auto shutoff times for component release and PCB
removal.
ix. Type the text for these three displays.
x. Run the activity log.
xi. Initiate prism calibration sequence. Further explanation is in par. 5e.
xii. Initiate heater arm sensor test. Checks proper orientation and operation
of heater arm position sensors.
xiii. Initiate camera sensor test. Checks proper orientation and operation of
camera position sensor.
xiv.
Initiate pick sensor test. Checks proper orientation and operation of pick
position sensor.
xv.
Blower test. Checks operation of heater blower.
xvi. Cooling fan test. Checks operation of cooling fan.
Figure 4
System Operations Manual
Page 9 of 38
xi
xii
xiii
xiv
xv
xvi
xvii
xviii
xix
Advertisement
Table of Contents
