Temperature Levels; Manual Override - Gabarron DILIGENS DIL4GC Installation Instructions And User Manual

3.4. TEMPERATURE LEVELS

In the AUTO mode, you can temporary change the set temperature for the time period. You can increase or decrease this
temperature simply by pressing the "+" or "-" buttons. Once the time period finishes, the temperature will revert back to the
programmed set temperature.
You can modify the set temperatures within the program permanently too, to do this, Press & Release the Config/Prog.
button until the display shows the flashing temperature symbol
you want to change, COMFORT or ECONOMIC, and use the "+" or "-" button to select the desired temperature.
COMFORT: Recommended for the periods of time when the user is at home and the maximum
comfort is required. Default value 19ºC.
FROST PROTECTION: Recommended for long away periods of time. Default value 5ºC.
It is possible to exit of temperature level configuration by pressing the Config/Prog button at any time.

3.5. MANUAL OVERRIDE

In manual mode, the heater will maintain the temperature set point and will ignore the pre-set program. By default, the initial
temperature set point is 19°C.
3.5.1 To modify the temperature set point, Press the "+" or "-" button until the desired temperature is shown. The heater will
now cycle on and off and maintain this temperature setting. If the room temperature goes below the set temperature, then the
heaters element will turn on and the symbol
the heaters element won't turn on and the heating symbol
3.6. OFF MODE
It is possible to put the heater in standby mode where the heater doesn't maintain any set temperature or run any programs,
keeping the time settings configured previously. When in this mode, the heater will display the current time and the word
3.6.1 To select the OFF mode, Press & Release the OK/Mode button until the display shows the current time and
3.6.2 If the heater is turned off via the main switch at the back of the heater or if the power to the heater is removed and the
heater is not connected to a Wifi G- Control Hub then the time setting within the heater will be lost.
ECONOMIC: Recommended for nights and small away periods of time. Default value 17ºC.
will be shown. If the room temperature is higher than the set temperature, then
. Now press the OK/Mode button to select the temperature
won't be displayed.
15
EN
.
.