Table of Contents
Advertisement
20
www.electrolux.com
10.2 Using the Child Lock
The Child Lock prevents an accidental
operation of the appliance.
If the Pyrolysis function
operates, the door locks
automatically.
A message comes on in the
display when you touch a
sensor field.
1. Activate the appliance.
2. Touch
3. Touch
until the display shows a message.
To deactivate the Child Lock function
repeat step 2.
10.3 Function Lock
This function prevents an accidental
change of the heating function. You can
turn it on only when the oven works.
1. Turn on the oven.
2. Set a heating function or setting.
3. Press
display shows: Function Lock.
4. Press
If the Pyrolysis function
works, the door is locked
and the symbol of a key
comes on in the display.
To turn off the function, press
display shows a message. Press
again and then
When you turn off the oven,
the function also turns off.
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it
later with one press of any symbol.
1. Turn on the oven.
2. Set a heating function.
3. Press
display shows: Duration.
4. Set the time.
.
and
at the same time
again and again until the
to confirm.
to confirm.
again and again until the
5. Press
display shows: Set + Go.
6. Press
Press any symbol (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, a signal
sounds.
10.5 Automatic Switch-off
For safety reasons the oven turns off
automatically after some time, if a
heating function works and you do not
change any settings.
30 - 115
120 - 195
200 - 245
250 - maximum
The Automatic Switch-off does not work
. The
with the functions: Light, Food Sensor,
Duration, End Time.
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the oven is
turned off, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the oven is turned on.
– if you touch a symbol during the
again and again until the
to confirm.
• Function Lock is on when
the heating function
works.
• The menu: Basic Settings
lets you turn the function:
Set + Go on and off.
(°C)
12.5
8.5
5.5
1.5
night brightness (apart from ON /
OFF), the display goes back to
the day brightness mode for the
next 10 seconds.
) to start
(h)
Advertisement
Table of Contents
