Oracle EXADATA X7-2 EF Installation Manual page 62

Remove the Cable Management Arm
Note -
Throughout the remainder of this procedure, the CMA must be supported until all the remaining
connectors are disconnected and the CMA can be placed on a flat surface.
Call Out
1
2
Use your right hand to support the CMA and use your left thumb to push in
b.
(toward the left) on the slide-rail latching bracket release tab labeled PUSH
(callout 2), and pull the latching bracket out of the left slide-rail and put it
aside [frames 3 and 4].
62 Oracle Exadata Storage Server X7-2 EF and HC Installation Guide • November 2018
After you disconnect connector D, do not allow the CMA to hang under its own weight.
Description
Connector D release tab (green)
Slide-rail latching bracket release tab (labeled PUSH)