Oracle EXADATA X7-2 EF Installation Manual page 56

Install the Cable Management Arm (Optional)
Note -
the latching bracket so that you can remove connector D.
11. Gently tug on the four CMA connection points to ensure that the CMA
connectors are fully seated before you allow the CMA to hang by its own weight.
To verify that the slide-rails and the CMA are operating properly before routing
12.
cables through the CMA:
Ensure that the rack anti-tilt bar is extended to prevent the rack from tipping
a.
forward when the server is extended.
Caution -
tilt bar before extending the server from the rack. For instructions on stabilizing the rack, see
"Stabilize the Rack" on page
b. Slowly pull the server out of the rack until the slide-rails reach their stops.
Inspect the attached cables for any binding or kinks.
c.
56 Oracle Exadata Storage Server X7-2 EF and HC Installation Guide • November 2018
The slide-rail latching bracket has a green release tab. Use this tab to release and remove
To reduce the risk of personal injury, stabilize the rack cabinet and extend the anti-
38.