Quantification And Scanning Quantification Mode Measurement Procedure - PerkinElmer LAMBDA 265 User Manual

Quantification and Scanning Quantification
Mode Measurement Procedure
Start the System Seflf Test after more than 20 minutes warming-up of the system.
NOTE:
1. Double-click UV Express
Quantification) modes for starting.
2. The following window will be shown. Empty the cell holder and close the lid firmly.
When performing System Self Test, both reference and sample cell holder have to be emptied.
NOTE:
Please remove cuvettes including the flow cell from cell holder.
3. Click OK after finishing the System Self Test.
4. Click New to open a new window. Select Experiment Type and click OK.
5. Click Method and set up parameters. For more detail of Quantification method,
refer to
6. Select Auto Sampler in the Accessory tab and then click Method setup.
folder and select Quantification (or Scanning
UV Express Software Users Guide
UV Express Software 59
.