Henny Penny LVE-202 Technical Manual page 59

Place connector on flat surface with the open side up.
7 7 ) )
Hold connector in place with one hand, use other hand to insert pocket knife
8 8 ) )
blade or other small sharp tool into connector notch to depress metal locking
tab.
Continue to hold locking tab down and pull lead wire out of the rear of connector
9 9 ) )
and remove probe from fryer.
Place nut and new ferule on new oil level probe and insert probe into
1 1 0 0 ) )
compression fitting.
Locate temperature probe through pot wall.
1 1 1 1 ) )
Place gauge against pot wall as shows in
1 1 2 2 ) )
page 49.
Figure 7-1 Probe Assembly Install ,
51