Henny Penny LVE-202 Technical Manual page 9

C C h h a a p p t t e e r r 1 1 T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
1 1 . . 1 1 I I n n t t r r o o d d u u c c t t i i o o n n
This section provides troubleshooting information in the form of an easy to rear table.
If a problem occurs during the first operation of a new fryer, recheck the installation
per the Installation Section of Operator's Manual.
Before troubleshooting, always recheck the Operating Section of Operator's Manual.
1 1 . . 2 2 T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g G G u u i i d d e e
To isolate a malfunction, proceed as follows:
Clearly define the problem (or symptoms) and when it occurs.
1 1 ) )
Locate the problem in .
2 2 ) )
Review all possible causes. Then one-at-a-time work through the list of
3 3 ) )
corrections until the problem is solved.
Refer to the maintenance procedures in to safely and properly make the
4 4 ) )
checkout and repair needed.
Problem Cause
POWER Open circuit.
switch on
but fryer
completely
inoperative.
Oil will not Blown or tripped
heat. fuse.
Faulty power
switch.
Faulty cord and
plug.
If maintenance procedures are not fol-
lowed correctly, injuries and/or property
damage could result.
T T a a b b l l e e 1 1 - - 1 1 T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g G G u u i i d d e e
• Check to see that unit is plugged in.
• Check breaker or fuse at supply box.
• Check voltage at wall receptacle
• Check main power switch; replace if defective.
• Check cord and plug.
• Reset circuit breakers in fryer.
• Reset transformer circuit breaker.
Reset circuit breaker or replace fuse at supply box or con-
trol panel.
Check power switch per
• Check cord and plug.
• Check power at receptacle.
Correction
7.8 Main Power Switch , page 44.
1