Henny Penny LVE-202 Technical Manual page 45

Perform steps seven and eight of
3 3 ) )
7 7 . . 5 5 H H i i g g h h T T e e m m p p e e r r a a t t u u r r e e L L i i m m i i t t S S y y s s t t e e m m
A thermocouple is attached to each element and senses oil temperature. if
temperature exceeds 425°F (218°C), a switch opens and shuts off heat to vat, and E-
10 error code is displayed. After oil temperature cools to a safe operating temperature
(15-20 minutes), high limit control must be manually reset. Reset switches are located
in the front edge of an electrical panel on the right side of the unit beside the JIB.
Open the right door, depress the raised part of the rocker switch for the affected
1 1 ) )
well, and release switch. If high limit resets, the oil starts heating. If high limit
does not reset, perform following checkout procedure.
7 7 . . 5 5 . . 1 1 C C h h e e c c k k o o u u t t
Open right door and remove the JIB.
1 1 ) )
Remove one screw and panel cover.
2 2 ) )
Locate thermocouple wires from element and disconnect from high limit.
3 3 ) )
Using a multimeter and the chart below, check the multivolt reading between the
4 4 ) )
thermocouple wires and compare with the chart of the J-Type thermocouple. If
the reading matches the chart, the thermocouple on the element is good and
continue onto the next step of checkout. If not, go to
39 to replace the thermocouple.
7.4.1 Control Panel Replacement , page 36
S S H H O O C C K K H H A A Z Z A A R R D D T T o o a a v v o o i i d d e e l l e e c c t t r r i i c c a a l l
s s h h o o c c k k , , m m o o v v e e t t h h e e p p o o w w e e r r s s w w i i t t c c h h t t o o o o f f f f a a n n d d
d d i i s s c c o o n n n n e e c c t t m m a a i i n n c c i i r r c c u u i i t t b b r r e e a a k k e e r r , , o o r r u u n n - -
p p l l u u g g c c a a r r d d a a t t w w a a l l l l r r e e c c e e p p t t a a c c l l e e . .
7.5.2 Replacement , page
37