Advertisement
Quick Start Guide
1.4
Install sensor
Figure 1-10: Sensor
A. O-ring PN 9550145
B. Light source
C. Detector
Procedure
1. Unscrew the nut on the side of the debubbler.
2. Insert the sensor in the mouth of the measuring chamber.
Be sure the pin on the debubbler lines up with the hole in the sensor.
3. Replace the nut.
4. Remove the protective cap from the sensor.
5. Screw the cable onto the receptacle.
The plug and receptacle are keyed for proper alignment.
The sensor is rated to IP65 when properly connected to the cable.
Postrequisites
To prevent possible water damage to the connector contacts, be sure the
cable receptacle and the connector on the back of the sensor are dry when
connecting or disconnecting the cable.
16
April 2020
Emerson.com/Rosemount
Advertisement
