Ricoh FAX180 Service Manual page 57

SERVICE TABLES AND PROCEDURES
BIT SWITCHES
Communication Switch 0B - Not used (do not change the settings)
Communication Switch 0C - Not used (do not change the settings)
Communication Switch 0D
No FUNCTION
The amount of remaining
memory below which
ringing detection (and
0
therefore reception into
to
memory) is disabled
7
(BRO only)
Communication Switch 0E
No FUNCTION
Minumum interval between
0
automatic dialing attempts
to
7
Communication Switch 0F - Not used (do not change the settings)
Communication Switch 10
No FUNCTION
Memory transmission:
0
Maximum number of dialing
to
attempts to the same
7
destination (BRO only)
Communication Switch 11
No FUNCTION
Immediate transmission:
0
Maximum number of dialing
to
attempts to the same
7
destination
Communication Switch 12
No FUNCTION
Memory transmission:
0
Interval between dialing
to
attempts to the same
7
destination (BRO only)
COMMENTS
00 to FF (Hex), unit = 2 kbytes
(e.g., 0C[H] = 24 kbytes)
One page is about 24 kbytes.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if there
is no memory space left. This will result in
communication failure.
(BR1: Do not change the setting.)
COMMENTS
06 to FF (Hex), unit = 2 s
(e.g., 06[H] = 12 s)
This value is the minimum time that the machine waits
before it dials the next destination.
COMMENTS
01 - FF (Hex) times
(BR1: Do not change the settings.)
COMMENTS
01 - FF (Hex) times
COMMENTS
00 - FF (Hex) minutes
(BR1: Do not change the settings)
4-26
August 7th, 1995