Table of Contents
Advertisement
August 7th, 1995
System Switch 06
No
FUNCTION
Use of the Stop key during
memory transmission (BRO
0
only)
0: Disabled 1: Enabled
1-7 Not used
System Switch 07 - Not used (do not change the settings)
System Switch 08 - Not used (do not change the settings)
System Switch 09
No
FUNCTION
Not used
0
Inclusion of communications
on the TCR when no image
data was exchanged.
1
0: Disabled 1: Enabled
Automatic error report
2
printout
0: Disabled 1: Enabled
Printing of the error code on
the error report
3
0: No 1: Yes
4
Not used
Power failure report (BRO
only)
5
0: Disabled 1: Enabled
Not used
6
Priority given to various
types of remote terminal ID
when printing reports
0: RTI > CSI > Dial label >
7
Tel. number
1: Dial label > Tel. number
> RTI > CSI
SERVICE TABLES AND PROCEDURES
COMMENTS
1: Memory transmissions can be stopped by pressing
the Stop key. However, users might accidentally cancel
another person's memory transmission in progress.
(BR1: Do not change the setting.)
Do not change the settings.
COMMENTS
Do not change the settings.
0: Communications which reached phase C (message
tx/rx) of the T.30 protocol are listed on the TCR
(Journal).
1: Communications which reached phase A (call setup)
of T.30 protocol are listed on the TCR (Journal). This
will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
1: Error codes are printed on the error reports.
Do not change the settings.
1: A power failure report will be automatically printed
after the power is switched on if a fax message
disappeared from the memory when the power was
turned off last.
(BR1: Do not change the settings.)
Do not change the settings.
This bit determines which set of priorities the machine
uses when listing remote terminal names on reports.
Dial Label: The name stored with the Quick/Speed Dial
number by the user.
4-17
BIT SWITCHES
Advertisement
Table of Contents
