Table of Contents
Advertisement
August 7th, 1995
System Switch 02
No
FUNCTION
Memory file transfer
(BRO only)
0: Disabled
0
1: Enabled
Programmed data transfer
(Back-to-back)
1
0: Disabled
1: Enabled
Not used
2
Memory file printout
(BRO only)
3
0: Disabled
1: Enabled
4
Not used
5
Not used
Memory read/write by RDS
Bit 7
6
Setting
0
0
Always disabled
0
1
User selectable
6
1
0
User selectable
1
1
Always enabled
7
System Switch 03
No
FUNCTION
Length of time that RDS is
0
temporarily switched on
to
when bits 6 and 7 of
System Switch 02 are set to
7
"User selectable"
SERVICE TABLES AND PROCEDURES
COMMENTS
1: All messages in the memory (including substitute rx
messages) are sent to the fax number which is
programmed as the service station.
Always reset this bit to zero after transfer.
Cross reference
Service station number programming: Function 13
(BR1: Do not change the setting.)
First, connect two machines of the same type back to
back. Then set this switch to 1 on the transmitting
machine. Then press Start on both machines. The data
is transferred. Set this bit to 0 again after finishing.
Do not change the setting.
1: All SAF files, including substitute messages, can be
printed using Function 51.
Always reset this bit after printing the messages.
(BR1: Do not change the setting.)
Do not change the settings.
Do not change the settings.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out, but
the user can temporarily switch RDS on to allow RDS
operations to take place. RDS will automatically be
locked out again after a certain time, which is stored in
System Switch 03 (see below). Note that if an RDS
operation takes place, RDS will not switch off until this
time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
COMMENTS
00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System Switch
02 are set to "User selectable".
The default setting is 24 hours.
4-15
BIT SWITCHES
Advertisement
Table of Contents
