Chapter 12 Setting Up The Operator Display; Calibrating The Operator Display - Trane Tracer MP581 Hardware Installation

CNT-SVN01C-EN
Chapter 12
Setting up the
operator display
This chapter shows how to calibrate the operator-display touch screen
and how to adjust the brightness and contrast. To set up the operator dis-
play screens and security, see the Tracer MP580/581 Programmable Con-
troller Programming guide (CNT-SVP01C-EN).
CAUTION
Equipment damage!
To clean the operator display, use a cloth dampened with commercial
liquid glass cleaner. Spraying water or cleansers directly on the screen
may result in equipment damage.

Calibrating the operator display

To calibrate the operator display:
1. On the home screen, press the Setup button. The Setup menu
appears.
2. Press the page down button to view the next screen.
3. Press the Calibrate Touch Screen button. A calibration screen
appears.
CAUTION
Equipment damage!
Do not allow the operator display to come in contact with sharp
objects.
4. Touch the target using a small, pliable, blunt object, such as a pencil
eraser. Hold until the beeping stops. A second calibration screen
appears.
5. Again, touch the target with the object. Hold until the beeping stops.
The Setup menu appears.
6. Press the Home button. The home screen appears.
65