Wire Routing - Trane Tracer MP581 Hardware Installation

Chapter 5 Wiring inputs and outputs
18

Wire routing

Figure 10 shows how to route input/output wires through the enclosure.
It also shows the locations of wire-tie brackets. See Figure 6 on page 11
for knockout locations and dimensions. Metal conduit may be required by
local codes when running input/output wires.
Note:
If your application requires a pressure sensor, install the pres-
sure sensor before wiring other inputs and outputs. (So that the
mounting holes are not covered by wires.) For more informa-
tion, refer to Chapter 6, "Installing the pressure sensor."
Figure 10. Wire routing
Brackets for wire
ties (9 locations)
Mounting holes for
pressure sensor
(sensor will affect
wire routing)
Recommended
communication wire route
CNT-SVN01C-EN