Removing The Door - Trane Tracer MP581 Hardware Installation

Chapter 9 Installing the door
58
3. Align the hinge pegs on the door with the hinge holes on the
enclosure.
4. Gently lower the door until it rests securely in the hinge holes.
5. Verify that the door swings freely on the hinges and that the magnetic
latches hold the door securely when it is closed.
6. For doors with an operator display, connect the operator-display cable
to the operator-display connectors (see Figure 36 on page 57).

Removing the door

Remove the door to simplify wiring or when upgrading the controller with
a door-mounted operator display.
To remove the enclosure door:
1. Open the door to a 90° angle from the enclosure.
2. For doors with an operator display, disconnect the operator-display
cable from operator display.
3. Lift the door to pull the hinges from the hinge holes.
CNT-SVN01C-EN