Assembly - Woodstock Shop Fox W1704 Owner's Manual

Model W1704 (For Machines Mfd. Since 01/20)

Assembly

Before beginning the assembly process, refer to Items.
Needed.for.Setup and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the Test.Run.or connecting
the machine to power.
To.assemble.machine,.do.these.steps:
1.. Install tailstock lock lever and M6-1 x 17 quill lock
handle, as shown in Figure 8.
2.. Install tool rest base lock lever and M6-1 x 28 tool
rest lock handle, as shown in Figure.9.
3.. Insert tool rest into tool rest base and tighten tool
rest lock handle (see Figure 10).
Note: Unless workpiece clearance is an issue, always
install the larger of the (2) tool rests included with
this machine to give yourself more room to work.
lock levers
Quill
Lock Handle
Figure.8. Hardware installed on tailstock.
Figure.9. Hardware installed on tool rest
Figure.10. Tool rest installed on tool rest
-17-
Tailstock
Lock Lever
Tool Rest
Lock Handle
Tool Rest Base
Lock Lever
base.
Tool
Rest
Tool Rest
Lock Handle
Tool Rest Base
Lock Lever
base.