Replacing Fuse; Replacing Brushes - Woodstock Shop Fox W1704 Owner's Manual

Model W1704 (For Machines Mfd. Since 01/20)
Replacing.Fuse
This machine features an onboard fuse designed to
protect sensitive electrical parts in the event of electrical
overload. If the fuse has blown, the motor will not start.
To verify the condition of the fuse, remove it from the
switch box and hold it up to the light. If the element is
broken, the fuse is blown and must be replaced.
Items.Needed.
Phillips Head Screwdriver #2 ..................................1
Fuse (PN X1704059) ............................................1
To replace fuse, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Remove fuse holder on back of switch box (see
Figure 39).
3. Remove old fuse from holder and install new fuse.
4. Re-install fuse holder in switch box.
Replacing.Brushes
This machine is equipped with a universal motor that
uses two carbon brushes to transmit electrical current
inside the motor. These brushes are considered to be
regular "wear items" or "consumables" that will need to be
replaced during the life of the motor. The frequency of
required replacement is related to how much the motor is
used and how hard it is pushed.
Replace both carbon brushes at the same time when the
motor no longer reaches full power, or when the brushes
measure less than ⁄ " long (new brushes are
1
4
Items.Needed.
Flat Head Screwdriver #2 ......................................1
Motor Brushes (PN X1704041V2-1) ...........................2
To replace motor brushes, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Remove brush caps (see Figure 40) and worn brushes
from motor.
3. Replace both motor brushes and re-install brush caps.
Qty
Figure.39. Location of fuse holder.
⁄ " long).
5
8
Qty
Figure.40. Location of motor brushes.
-37-
Fuse
Holder
Brush Cap
(1 of 2)