5
Wire 4-pin terminal block
5.1
Strip 2 in (50 mm) of the jacket
off the cable run from the wall.
5.2
Wire the 4-pin terminal block (provided) to the cable using a screwdriver.
Make sure to tighten the screws tightly and that no insulation is inside of the
terminal block.
Notes:
The EDU connector will support wire sizes from 12 AWG (2.5 mm²) to
•
26 AWG (0.2 mm²). See the instruction sheet for your power supply
to choose an appropriate wire size for your application.
Strip insulation from wires so that 0.25 in (6 mm) of bare wire is exposed.
•
Page 9
Sivoia
QS
®
roller 100
Pocket Mount
TM
}
MUX (Pin 4)
MUX (Pin 3)
To EDU
24 V
(Pin 2)
Connector
Common (Pin 1)
Installation instructions