Table of Contents
Advertisement
Table 3: Interfaces
Interfaces vary by model; not all models will have all of the interfaces listed.
Interfaces
USIM
LAN
RESET
DC-5V Power Connector
Power Switch
POTS-RJ11
(Atom ID06-6.5 only)
5.
Installation & Configuration
5.1
Physical Installation
The steps for installing the unit are provided below.
IMPORTANT: Make sure the unit is turned off before you insert or remove
the USIM card. Otherwise, the unit and card may be damaged.
Insert the USIM card: Open the protective cover of the USIM card slot on the top of the Atom
1.
unit, and insert the USIM card into the slot (Figure 4). Close the cover.
Figure 4: Insert USIM Card
2.
Connect the cables (per previous Figure 3), and power on:
a. LAN: Connect one end of the RJ-45 Ethernet cable to the LAN interface on the back of
the unit. Connect the other end to a computer or other LAN device.
b. Power: Connect the DC-5V power adaptor to the power connector on the back of the
unit. Plug the other end into an electrical outlet.
c. Turn the power switch to ON.
Universal Subscriber Identity Module card slot. 1.8V/3.0V USIM 2FF
One to four RJ-45 ports, LAN, 10/100 (CAT4) or 10/100/100 (CAT6/7) auto-
sensing, auto-MDX interface to connect to computer or other network
devices (e.g., hub or switch). Compatible with IEEE 802.3/802.3u standards.
Press the reset button for 1 second to reset the unit. Press the reset button
for 10 seconds to restore the unit to its factory settings.
Port to attach the power adaptor provided with the unit
Power on/off
RJ-11 telephone port(s). Used for phone / fax / POS, providing VoIP functions
under conditions of software support.
4
Description
Advertisement
Table of Contents
