3D Systems CubePro Manual page 4

Hide thumbs Also See for CubePro:

WARNING: THE CUBEPRO SHOULD ONLY BE SERVICED BY AUTHORIZED

SERVICE TECHNICIANS. PRIOR TO

ANY PART REPLACEMENT PROCEDURE, THE PRINTER MUST BE

POWERED OFF AND DISCONNECTED FROM

UTILITY POWER.

HOT SURFACE HAZARD: WHEN PRINTING WITH ABS MATERIAL, THE

INTERIOR (PRINT CHAMBER) OF THE

PRINTER WILL HEAT TO A PREDETERMINED TEMPERATURE. THE

SURFACE OF THE PRINT CHAMBER HEATER

WILL BE HOT. AVOID CONTACT WITH THE PRINT CHAMBER HEATER AND

NOTE THAT OTHER COMPONENTS

INSIDE THE PRINT CHAMBER MAY BE HOT.

To ensure safety, please exercise caution when operating your CubePro. Read and follow all

safety precautions as outlined in this

user guide. Be careful when operating your CubePro to ensure proper printing and be

mindful of and avoid hot surfaces.

Table of Contents

Need help?

Do you have a question about the CubePro and is the answer not in the manual?