Download Print this page

3D Systems CubePro Manual page 17

Hide thumbs Also See for CubePro:

Advertisement

Loading Nylon
Loading Nylon
Install nylon cartridges using the Change Cartridge utility in the Setup menu. Once the
cartridge has been installed, it is important to purge the print jets to remove all previously
used print material that may remain in the extruder assembly.
1.
Navigate to the Print Jet Calibration screen and select
2.
Select the print jet that has been loaded with nylon print material.
3.
Select the target temperature value. Select the up arrow until the target temperature
value reaches 275°C.
NOTE: To increase or decrease the temperature value, press the up or down
arrow.
NOTE: The current temperature reading will appear above the target
temperature value.
CONTROL
JETS.

Advertisement

loading
Need help?

Need help?

Do you have a question about the CubePro and is the answer not in the manual?