Diagnostic Selection Modify Screen Description - IBM 3745 Series Service Functions

Screen Descriptions
Diagnostic Selection Modify Screen Description
I
R RERUN REQUEST
I
A ABORT ROUTINE
I
C
CAHCEL REQUEST I
G GO
I
H MODIFY OPTIONS: I
S/LS/AL/ALS/B/D'"
I
HH/H I START 00:26:25
Cl/CNNN/C
I
REQUEST: ALL DIAGNOSTICS INITIALIZATION
R1/RNNN
I
OPTIONS: S NH C1 R1 BR
BR/NBR I
===>
I
I ENTER REQUEST ACCORDING TO THE DIAG "' E NU
I
==>
~!
OM
\~
Fl: END F2: 1·!ENU2 F3: ALARI·!
Figure 3-12. Diagnostic Selection Modify Screen
The menu to the left of the screen lists the following set of commands:
R- RERUN: The current request will run again.
A
ABORT routine
C
CANCEL: The current request is canceled, allowing a new request. The
current set of options is reset.
G GO
• Selection modify me~lU: after your request is entered on the screen,
GO starts the execution.
• Execution modify menu: after your request is entered on the screen,
GO resumes the execution.
M MODIFY OPTIONS
All the available options are listed, separated by a slash (/). On a given
line, the options are mutually exclusive. You may select several options,
one per line of the menu. For example:
M C5 OM
will cause your request to cycle 5 times, and display multiple errors.
However, if you select more than one option for the same line, only the
last one is accepted.
If you do not select any option, the following defaults are set:
S NW Cl Rl BR
See "Diagnostic Selection Modify Screen Description" for the explanation
of all the options.
To leave the modify option (M), enter any command (A, C, G, or R).
3-16
3745 Communication Controller