Table of Contents
Advertisement
No IBM Copyright Screen For Local Operator Console
• Make sure that MOSS has been IMLed. For an mM PC only, make sure that
MOSS has been IMLed after setting your IBM PC to 3101 emulation mode.
Check the Power Check lamp on
the control Danel.
I
A
Check the MOSS Inoperative lamp
on the control panel.
Check the Remote Console Active lamp
on the control panel.
Check if TERMINAL DISCONNECTED
FOR REMOTE CONSOLE is displayed.
Check the console cable and cable
connections.
Check if the console parameters have not
been modified (speed, etc.).
If none of the above applies:
If on: Go to page 5-1.
If on: Go to page 5-3.
If on: Go to page 2-3.
If it is: Go to page 2-3.
•
Connect or reconnect correctly.
•
If the connection is correct, perform a
Console Link Test. Go to page 9-1
If they have been modified, reset to original values. Refer to
3720/3721 Communication Controller System Integration.
• Set the Panel/Console switch to Panel unless already set.
• Activate the Remote CNSL Disconnect Request switch.
If the IBM Copyright screen does not appear:
- First perform the problem determination described in the operator
console documentation.
- If the problem persists:
@
(Go to page viii)
2-2
3720/3721 Communication Controller Problem Determination Guide
Advertisement
Table of Contents
