Cdf Upgrade; Cdf Verify - IBM 3745 Series Service Functions

CDF Verify
CDF Upgrade
One CCU Power Off on a 2-CCUs 3745
~~~~~~~~~~~~~~~~~~~~~~
On a 2-CCUs 3745 with one CCU powered down (either manually or automatically), you must
perform a
pas
create before any COF upgrade (refer to "Recreating the PS 10 Configuration Table"
on page 12-16). If the
pas
create is not performed, the COF upgrade will abort.
You must be in MOSS
alone.
1. You must be in the COF function (see page
9-7).
2. In
0
of this screen, type 3, and press SEND.
3. Screen
m
is displayed.
You cannot perform a CDF upgrade if you have
previously canceled an IPL in phase 1.
No action is needed.
• On the scree, the process is similar to the
CDF create.
• All the information entered manually is kept.
If the CCU information is in error on:
• CCU-A, the CDF function is aborted.
• CCU-8, the CDF function 'will continue on
CCU-A only.
Refer to "COF Create/Upgrade/Verify Field
Explanations" on page 9-11 for more details.
CDF Verify
CoSTC'lER 10: 37';~ SERIAl ',cI8ER:
C:H PRC:fSS
mtt'!!@J
R",\j S:;;P-I:lC-Crot< SiOP_~CU-C"'r< RC
CCU-8 PRC:ESS
mttl!!@J
R(,~ STcP-IOC-:HK STOP-CCu-CrK >Ie
-- - - _. - - - - -- - _. - --- -- - -- -- - - - - - - - - - - - - - -- - - - -- - - - - - - - -- - - -- - - - -mm/dd/yy hh
:"111
Hi
IiI!:[; ii'l:fj
SELECT ONE CDF FUNCTION
(! TO 4), THEN PRESS Sf NO
~~>
0
1 ~ DISPLAY/UPDATE
Z
~ CR,
>lTE
3
~
l!mlt1lIJ
4 ~ VtRlfY
Fl :END F3:ALARM
Figure 9-7. CDF Functions Selection Screen
cor
UPGRADE STARTED
vvvv INSTAllED POwfR S"PPlIES ARE vvvv
flOSS INFORMATION: FETCHED
CCU
ItJFOR~IATION:
yyyyyyy ON CCU x x
SWITCH ItJFORMATION : yyyyyyy ON SW
x x
CA ItJFORMATION : yyyyyyy ON CA ~x
xx xx xx xx xx xx xx xx xx
AX
SCANNER IHl : COMPLETED
~. xx xx
AX
xx
lA
cor
UPGRADE COMPLETED
Fl :END F3:ALARM F6:QUIT
Figure 9-8. CDF Upgrade Screen
OneCCU Power Off on a 2-CCUs 3745
~~~~~~~~~~~~~~~~~~~~~~~
On a 2-CCUs 3745 with one CCU powered down (either manually or automatically), you must
perform a
pas
create before any CDF upgrade (refer to "Recreating the PS ID Configuration Table"
on page 12-16). If the
pas
create is not performed, the CDF upgrade will abort.
This function compares the contents of the COF on the MOSS disk with the information gathered from
the sensing of the installed hardware elements. Any discrepancy produces a message, for acknowl-
edgement or updating:
FRU level problem
Contact your local support structure.
Chapter 9. Configuration Data File (CDF)
9-9