Use Ca Basic Commands Function - IBM 3745 Series Service Functions

CA Basic Commands
1. Enter parameter(s) in
0
and
D
(if TPS is
not present), or in
0
to
D
(if TPS is
present).
2. Press SEND.
The information is saved on disk. It is displayed
on the first screen after local console power ON
(see Figure 1-4 on page 1-6), or can be displayed
by using the CID function (see details in the
Advanced Operations Guide).
When TPS is not present, the 'INTERFACE B' data
area is not displayed.
Use CA Basic Commands Function
1. You must be in the CAS function (see page
10-2).
2. Enter 3 in
D.
3. Press SEND.
4. The next screen is displayed.
1. In
0,
enter the CA number.
2. Press SEND.
3. Screen
II
is displayed.
The selected CA must be present.
10-4
3745 Communication Controller
D
CA
xx
HOST ATTACHMENT INFORMATION
- FILL Irl, OR MCGiFY, CR BLArlK FO.LCI/;"3 FIE,DS, T~EN PRESS SE'IQ
FI :ENJ
F3:AlAR~1
F6:0UiT
Figure 10-7. CA Host Attachment Information Screen
SELECT ONE OPTION
(I TO 4). THEN PRESS SOlO ==>
D
1 = DISPLAY CA AND INTERFACE STATUS
2
=
Dr'I'IE ~OST ATTA::~'lENT I',<OR'lATlON
3
=
USE CA BASIC CIMtANDS
<\ = u~t: CA CONCURRt:IH MAINT!:t./lrJCt CO~lr'IANDS
FI :ENQ F3:ALARM
Figure 10-8. CA Services Function Selection 1 Screen
- SELECT ONE OPTION (I TO 4), THEN PRESS SEND
1
=
DISPLAY CA AND INTERFACE STATUS
2 = DEFINE HOST ATTACHMENT INFORr'IATION
3 =
USE CA BASIC coril-IANDS
4 =
USE CA CONCURRENT MAlNTErJ/lNCE COflMArIDS
ENTER CA NUMBER
(I TO 16)
==>
D
Fl :END F3:ALARf1 F6:0UIT
Figure 10-9. CA Services Function Selection 2 Screen