Appendix 2 Messages And Led - Toshiba B-492L Owner's Manual

APPENDIX 2 MESSAGES AND LEDS
APPENDIX 2 MESSAGES AND LEDS
Appendix 2 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated.
2: ****: the remaining number of labels to be printed. Up to 9999 (pieces)
3: %%%%%%%: ATA Card's remaining memory 0 to 9999999 (in K bytes)
4: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
5: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
LCD Message
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Display of error
19
message (See Notes.)
: The LED is flashing.
LED Indication
POWER ONLINE ERROR
In online mode
In online mode (The printer is receiving
a communication)
The print head block is opened in online
mode.
The printer is paused.
A parity, overrun, or framing error has
occurred during communication through
the RS-232C port.
The media has jammed during feed.
The media has run out, or the media is
not loaded correctly.
The ribbon has run out, or has snapped.
A problem has occurred with the sensor
that determines the torque for the ribbon
motor.
Feeding or printing was attempted with
the print head block open.
Feeding or printing was attempted with
the top cover open.
Feeding or printing was attempted with
the pinch roller raised.
Feeding or printing was attempted with
the strip pinch roller unit open.
Feeding or printing was attempted with
the media guide plate removed.
The print head has overheated.
In writable character or PC command
save mode
An error has occurred while formatting
the flash memory or ATA card.
An
formatting the flash memory or ATA
card.
Data cannot be stored because the flash
memory or ATA card is full.
There is a problem with the print head.
The data analyzer has found an error in
the displayed command.
A2- 1
: The LED is unlit.
Printer Status
erase error has occurred
EO1-33032
APPENDIX 2 MESSAGES AND LEDS
Restoration Acceptance of
by RESTART Status Request
key Yes/No Reset Command
-----
-----
-----
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
-----
No
in No
No
Yes
Yes
Yes/No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes