Lcd Messages And Led Indications - Toshiba B-EX Series Operation Manual

6.8 LCD MESSAGES AND LED INDICATIONS

LCD Message
nd
No
2 line
（English）
ONLINE
1
ONLINE
2 HEAD OPEN
3 PAUSE
4 COMMS ERROR
5 PAPER JAM
6 CUTTER ERROR
7 NO PAPER
8 NO RIBBON
9 HEAD OPEN
10 HEAD ERROR
EXCESS HEAD
11
TEMP
12 RIBBON ERROR
13 REWIND FULL
SAVING ####KB/&&&&KB
14
or
LED
indications
ON
ERROR
LINE
In the online mode
○ ●
In the online mode
●
(Communicating)
A feed or an issue was attempted
● ●
with the head opened.
In a pause state
● ●
A parity error or framing error has
● occurred during communication by
RS-232C.
A paper jam occurred during paper
feed.
Paper was not set properly.
Label
selected media sensor type do not
match.
The media sensor position does
not align with the black mark
●
position.
The actual media size and the
specified media length do not
match.
The level of media sensor is not
suitable for the actual media.
The gap
detected due to pre-printing.
A paper jam occurred in the cutter.
The cutter did not move from the
●
home position.
The cutter cover was open.
The media has run out.
The media has not been set.
●
Media sensor level is not suitable
for the paper used.
● The ribbon has run out.
A feed or an issue was attempted
with the head opened.
●
(Except media feed caused by the
[FEED] key or Expansion I/O)
A broken dot error has occurred in
the thermal head.
●
The error has occurred in the head
driver.
The thermal head temperature has
●
become excessively high.
An abnormal condition occurred
with the sensor for determining the
torque of the ribbon motor.
●
A ribbon jam occurred.
The ribbon has been torn.
The ribbon has not been set.
An overflow error has occurred in
●
the rewinder unit.
Writable
●
command save mode.
Printer status
actually used and
of label cannot
characters or
18
Acceptance of
Restoration by
Status Request
the [RESTART]
key
Yes/No
－
－
－
Yes
Yes
the
Yes
be
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
PC
－
and Reset
Command
Yes/No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes