Toshiba B-492L Owner's Manual page 75

APPENDIX 4 SYSTEM MODE
A4.8.2 Maintenance Counter and Parameter Check Print Sample and Descriptions
(Cont.)
Descriptions of the Maintenance Counter
No. Item
(1) Total media distance covered
(2) Media distance covered
(3) Print distance
(4) Head up/down count
(5) Ribbon motor operating time
Head up solenoid operating
(6)
time
(7) RS-232C hardware error count
(8) System error count
(9) Momentary power failure count
NOTES:
1. The item from (2) through (9) are initialized to "0" after RAM clear.
2. If the Print distance is 5.5m or less, it is rounded down and no data is added to the memory at power off.
3. If the count is 31 counts or less, it is rounded down and no data is added to the memory at power off.
4. If the driving time is 27 sec. or less, it is rounded down and no data is added to the memory at power off.
5. When more than 1 byte-data is continuously sent, they are counted by byte.
6. If the media distance covered is 69.4 cm or less, it is rounded down and no data is added to the memory at
power off.
Descriptions of the Parameters
No.
(10) Feed length fine adjustment (PC), (KEY)
(11) Strip position fine adjustment (PC), (KEY)
(12) Back feed length fine adjustment (PC), (KEY)
Print tone fine adjustment (Thermal transfer), (PC),
(13)
(KEY)
Print tone fine adjustment (Thermal direct), (PC),
(14)
(KEY)
Ribbon rewind motor driving voltage fine adjustment
(15)
(PC), (KEY)
Ribbon feed motor driving voltage fine adjustment
(16)
(PC), (KEY)
(17) Strip Motor driving speed fine adjustment (PC), (KEY) +0 to +4
(18) X axis fine adjustment
Count Condition
Counted when the feed motor is driven to feed,
print and issue the media. (Also counted
during back feed.) See NOTE 6.
Counted while printing. (Back feeding is not
counted.) See NOTE 2.
Counts every print head up and down
movement using the ribbon saving solenoid.
(Up + down=1 count) See NOTE 3.
Counts when the ribbon motor is driven to feed,
print and issue media. (The driving time is also
counted during back feed.) See NOTE 4.
Counted during the ribbon saving.
See NOTE 4.
Counted when a parity, overrun or framing
error occurs. See NOTE 5.
Counted when any error occurs.
Counts the number of times the power restores
while the CPU is busy after reset.
Item
A4-25
Contents
-50.0 mm to +50.0 mm
-50.0 mm to +50.0 mm
-9.9 mm to +9.9 mm
-10 step to +10 step
-10 step to +10 step
-15 step to +0 step
-15 step to +0 step
-99.5 mm to +99.5 mm
EO1-33032
A4.8 Additional Information
Range
0.0 to 2000.0 km
0.0 to 181.9 km
0.0 to 200.0 km
0 to 2000000 times
0 to 2000 hours
0 to 1000 times
0 to 255 times
0 to 15 times
0 to 15 times