Loading The Media - Toshiba B-492L Owner's Manual

2. PRINTER SETUP

2.7 Loading the Media

WARNING!
1. Do not touch any moving
parts. To reduce the risk
of fingers, jewellery,
clothing, etc. being
drawn into the moving
parts, be sure to load the
media once the printer
has stopped moving
completely.
2. To avoid injury, be
careful not to trap your
fingers while opening or
closing the cover.
3. Be sure to open the top
cover fully, otherwise the
top cover may close,
causing injury.
NOTES:
1. When the head lever is
@
turned to position
print head is raised.
2. When the pinch roller lever
is turned to position
pinch roller is raised.
3. To enable printing the head
lever and the pinch roller
lever must be set to position
?
. This ensures that the
print head and the pinch
roller are closed.
This section describes in detail how to load the media.
1. Open the top cover and turn the head lever and pinch roller lever to
position
Top Cover
2. Insert the media into the printer from the side as shown in the figure
below. Ensure that the media is positioned in the black mark/feed gap
, the
sensor.
@
, the
d
, then open the ribbon shaft holder plate.
c
d
HEAD
Head Lever
2- 6
EO1-33032
2.7 Loading the Media
1
2
Pinch Roller
Lever
Ribbon Shaft
Holder Plate
Media