Table of Contents
Advertisement
2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
(4) Pass the backing paper under the strip plate and above the strip pinch
roller.
(5) While pulling the backing paper push up the strip pinch roller until it
locks into position.
(6) If the loaded media is direct thermal media (a chemically treated
surface), the media loading procedure is now complete. Close the
ribbon shaft holder plate, and turn the head lever and the pinch roller
?
lever to position
If the media is a standard media, it is also necessary to load a ribbon.
Refer to the following section, 2.8 Loading the Ribbon.
2-10
to close. Then, close the top cover.
EO1-33032
2.7 Loading the Media
Advertisement
Table of Contents
