Table of Contents
Advertisement
APPENDIX 4 SYSTEM MODE
A4.6 Test Print (Cont.)
Print Sample of Characters
Print Sample of Barcodes
NOTE:
The Non-Printing function
looks like a media feed.
Print Sample of Non-print
NOTES:
Factory test print conditions:
One paper feed, Slant lines (3
dots), Bar codes, Characters,
Item count: 5 pcs. each, Print
speed: 5"/sec., Sensor type:
Black or Feed gap sensor
Ribbon type: Transparent
When the feed gap sensor is
selected, a gap length is 3
mm.
Print method: Thermal
transfer, Issue mode: Batch
printing, Label length: 76
mm, Print tone fine
adjustment.
Characters
While displaying the Characters, press the [PAUSE] key to start printing
the characters. After printing is completed, the display returns to
"<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to show "CHARACTERS"
again. Then, press the [FEED] key.
Barcode
While displaying the Barcode, press the [PAUSE] key to start printing
the bar codes.
After printing is completed, the display returns to
"<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to show "BARCODE"
again. Then, press the [FEED] key.
Non-Printing
While displaying the Non-printing, press the [PAUSE] key to start
issuing a blank page of media. After printing is completed, the display
returns to "<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to show "NON-
PRINTING" again. Then, press the [FEED] key.
Factory Test
While displaying the Factory test, press the [PAUSE] key to start
printing the factory test pattern. After printing is completed, the display
returns to "<4>TEST PRINT".
Pressing the [PAUSE] key causes the display to indicate "FACTORY
TEST" again. Then, press the [FEED] key.
A4-19
EO1-33032
A4.6 Test Print
Advertisement
Table of Contents
