Dip Switch Settings - ABB NCAN-02 Installation And Startup Manual

Chapter 4 – Electrical Installation

DIP Switch Settings

Press down the
1
clips on top
and bottom of
the module.
4-2
The DIP switches SW1 and SW2 on the NCAN printed circuit board
can be used to select the node number and the baud rate for the
module.
Setting switch SW1:8 to ON enables DIP switch selection. In this case,
the corresponding selection parameters (in the fieldbus parameter
group; see Chapter 5) only act as read-only indicators.
If SW1:8 is set to OFF (default), the node number and the baud rate
are selected through module parameters (see Chapter 5).
The figures below show how the DIP switches on the circuit board can
be accessed.
1 2 3 4
5 6 7 8
Bottom View
Pull the PCB outwards.
2
(Stoppers prevent the PCB from
being completely removed.)
Side View
NCAN-02 Installation and Start-up Guide