Kongsberg Simrad Robertson AP300X Series Instruction Manual page 91

Loosen the end bolt (a) used to secure the cylinder to the drive unit
mount. Insert the rod retaining assembly (b) (end plate) and retighten this
bolt. Secure the feedback rod to the end plate using the two washers
and cap nut provided. Adjust the location of the LF3000 Linear
Feedback to allow full travel of the hydraulic cylinder without causing
the endplate of the LF3000 hitting the end of the cylinder. Check that
the outboard motor can be tilted freely. Tighten all nuts and the
mounting bracket.
Turn the helm slowly by hand to the stops on either side, making sure
that the rod does not bind up in any direction. Also, clamp cable to
allow full engine movement to port and starboard. The mounting
hardware provided with this system is meant to interface with Teleflex
HC5340 cylinders and Hynautic K7 and K10 Cylinders. If you are
attempting to interface to another system the hardware enclosed may
not be appropriate! Contact your dealer to obtain the correct mounting
kit.
CYLINDER
a
b
22081814H
LF3000
BRACKET
LINEAR FEEDBACK
INTERFACE
TB1
LFI3000
TB2
Installation
JUNCTION UNIT
MAIN PCB
Rudder
Feedb.
89