Kongsberg Simrad Robertson AP300X Series Instruction Manual page 78

Robertson AP300X Autopilot
• Hold the Control unit in place by hand and mark the 4 holes for the
• Remove the Control unit, drill the 4 mounting holes in the
• Unbolt the temporarily fitted bracket halves and screw them to the
• Assemble the complete bracket again and adjust the control head to
• Connect the Robnet cables to the control unit connectors
• Use the supplied AP300/AP300DL BEZEL MOUNTING CUT-OUT
• If watertight mounting is required, add some silicon around the
• Carefully tighten the screws making sure the bezel is not bent.
• Set the large "O-Ring" around the inside lip of the control head
• Connect the Robnet cables to the control unit connectors.
• "Snap" the Control unit into the bezel mount.
76
fixing screws on the mounting surface.
mounting surface.
mounting surface.
best viewing angle and tighten up the mounting bracket bolts.
Figure 3-6 AP300CX Bezel
top mounting
template to make the exact cut out for the connectors. Fasten the
bezel to the panel by the 4 (6) countersunk screws. (Numbers in
brackets are for AP300DL).
mounting bezel flange before mounting.
mounting flange.
Figure 3-7 AP300DLX Bezel top
mounting
22081814H