Kongsberg Simrad Robertson AP300X Series Instruction Manual page 55

• Adding from the prevoiusly stored waypoints to the route list.
• Pressing "Enter" after creating the complete route.
The MOB waypoint and TEMP-WP may not be used as part of a route.
Note !
NORTH
WEST
PORT
00
PLOT INSTR INFO
MOB
Flashing Cursor prompt
Edit the route name here.
Use a unique name that
identifies the route
Route Name
Waypoint gets
added at pointer
in Route List
If you make an ERROR, refer to the
opposite page: "Correction of routes"
You must press ENTER after creating a route to save it to memory.
Use the course selector to point at the first waypoint in the waypoint
list that will be added to the route list. Then press the ADD key.
Each time you press the ADD key, the waypoint selected in the
waypoint list will be added to the route list, and the WP insert pointer
will be set below the last waypoint that was added to the new route.
22081814H
GPS1 POSITION
EAST
N 40°52.60'
W 72°30.15'
STBD
COG : 075°M
NAV
MAIN
SETUP ROUTE
Route - 00
ESC DEL MAIN
Peconic 1
Canal 1
MAIN
ESC DEL
Select
route
SOG : 5.00Kt
Selected
Route:
Route info:
Name: Route -00
WAYPT GOTO
Start: NONE
End:
Next: - - - -
ESC
The next available route is automatically
presented as the new route.
Edit
Robertson
Use
Route
Name
for route name
Move cursor
< or >
Use the
Change value
cursor to character field.
Move cursor out of name field to
proceed to next menu.
1. Turn
to move pointer to waypoint
MOB - WP
TEMP - WP
that will be inserted into route.
Canal 1
Buoy 26
2. Press ADD to add
LP Bay
Nassau22
the chosen waypoint
Jessup17
Noyack16
to the route list
XXXX - 008
XXXX - 009
Repeat Steps 1 and 2 for each
ADD ENTER
waypoint that will be added to
the route.
Press Enter only when finished
adding waypoints to the route
list.
Autopilot Operation
ROUTE - 00
ROUTE - 01
ROUTE - 02
ROUTE - 03
ROUTE - 04
ROUTE - 05
ROUTE - 06
ROUTE - 07
ROUTE - 08
NONE
ROUTE - 09
GOTO MAIN ADD EDIT
to select characters
or to move
Roberts on
53