Installing Drainpipes - Huawei FusionModule1000A20 Installation Manual

FusionModule1000A20 IT Solution
Installation Guide (2016.05, AI Version)
Figure 7-2 Installing water refill pipes
Step 2 Install a PP-R external thread connector, as shown in
Step 3 Hot-melt the DN32 PP-R pipe and the PP-R external thread connector, as shown in
7-2.
Step 4 Wrap the exposed parts of the pipes with 10 mm thick thermal insulation foam.
----End
Follow-up Procedure
Verify that the pipe connector is closely melted with the pipes at both ends.

7.3.2 Installing Drainpipes

Prerequisites


Context
This section describes only how to install water drainpipes on drainage ports of the
FusionModule1000. The other water drainpipes are routed and installed depending on onsite
situations under the guidance of onsite supervisors.
Preparations
Tools: protective gloves and hot melt device
Issue 02 (2017-01-10)
Drainpipes that meet requirements have been prepared.
The positions for installing drainpipes have been specified.
The drainpipe installation plan for the FusionModule1000 meets the drainage requirements and
principles.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Installing External Cooling Devices
Figure 7-2.
Figure
33