Tightening Torques For Power Connections; Applicable Standards - ABB ACQ800 Series Hardware Manual

ACQ800-37 Hardware Manual
Disposal

Tightening torques for power connections

Screw size Torque

Applicable standards

• EN 61800-5-1:2007
• EN 60204-1:2006 +
A1:2009
• EN 60529:1991 (IEC 60529) Degrees of protection provided by enclosures (IP code)
• IEC 60664-1:2007
• EN 61800-3:2004
• UL 508C:2002, Third Edition UL Standard for Safety, Power Conversion Equipment
• CSA C22.2 No. 14-10
The drive contains raw materials that should be recycled to preserve energy and natural
resources. The package materials are environmentally compatible and recyclable. All
metal parts can be recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations. Most recyclable parts are marked
with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit
boards can be landfilled. The DC capacitors (C1-1 to C1-x) contain electrolyte and the
printed circuit boards contain lead, both of which are classified as hazardous waste within
the EU. They must be removed and handled according to local regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
M5 3.5 Nm (2.6 lb-ft)
M6 9 Nm (6.6 lb-ft)
M8 20 Nm (14.8 lb-ft)
M10 40 Nm (29.5 lb-ft)
M12 70 Nm (52 lb-ft)
M16 180 Nm (133 lb-ft)
The drive complies with the following standards. The compliance with the European Low
Voltage Directive is verified according to standards EN 61800-5-1 and EN 60204-1.
Adjustable speed electrical drives. Part 5-1: Safety requirements. Electrical, thermal and
energy.
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device
- the drive module into a cabinet.
Insulation coordination for equipment within low-voltage systems. Part 1: Principles,
requirements and tests.
Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods.
Industrial control equipment
121
Technical data