YILMAZ KD 350 M-D-P User Manual page 25

7.2 Operation
7.2.1 Place PVC or aluminum profile that you are going to process on to the table (FIGURE 1 NO.5). Fix it with
clamps (FIGURE 1 NO.75 / 88) on the table.
7.2.2 KD 350-400 M/D: The clamping is manual. KD 350-400 P: Clamping is pneumatically
backward, up-down position of the clamps with special clamping parts (FIGURE 1 NO.77/78). Control of
pneumatic clamp is made with the button (FIGURE 1 NO.71) on the chassis (FIGURE 1 NO.1).
7.2.3 Control the firmness of the special clamping screw (FIGURE 2 NO.89) on set square (FIGURE 1 NO.25)
7.2.4 Operate the motor by pressing the start button (FIGURE 1 NO.66-1) on arm (FIGURE 1 NO.66)
7.2.5 After cutting off the material, bring the cutting grip to its original position, press the Stop button. The saw blade
will come to a full stop after continuing its idle rotation for a while.
7.2.6 After cutting off the material, bring the cutting grip to its original position, press the Stop button. The saw blade
will come to a full stop after continuing its idle rotation for a while.
7.2.7 Remove the part by opening the clamps.
Don't operate the saw while it touches the work piece. The saw must be operated only when the head
is in the top position.
.
You can adjust forward-
47